![]() |
-stdout syntax - Printable Version +- hashcat Forum (https://hashcat.net/forum) +-- Forum: Deprecated; Previous versions (https://hashcat.net/forum/forum-29.html) +--- Forum: Old hashcat Support (https://hashcat.net/forum/forum-20.html) +--- Thread: -stdout syntax (/thread-1094.html) |
-stdout syntax - -.-PhanTom-.- - 04-19-2012 Hi I just discovered hashcat today and wanted to use the --stdout function (on windows) But I am unsure which syntax to use.. I have tried: >hashcat-cli64.exe --attack-mode 1 --stdout wordlist.txt >> output.txt But it seems the syntax is not right... please advice. Besically I just wanted to see the manipulations that are done to words using the attack mode 1 filter Regards PS: are absolute file locations neccessary on windows and can you just use simple naming when the file is located in the same folder? RE: -stdout syntax - atom - 04-19-2012 I know it does not make much sense, but you have to add two parameter to it (they are not used). This will be fixed with 0.40 hashcat-cli64.exe --attack-mode 1 --stdout wordlist.txt x x >> output.txt RE: -stdout syntax - -.-PhanTom-.- - 04-19-2012 Thanks a lot for the fast reply, much appreciated! ![]() Is it right to assume, that my current gfx card Radoen HD5800 does not support the OCL version? RE: -stdout syntax - atom - 04-19-2012 All hd58xx are supported. RE: -stdout syntax - -.-PhanTom-.- - 04-19-2012 Hmm ok.. I tried using the gui for the ocl, but all that happens is that a command prompt windows pops up and that's it this is the syntax used: oclHashcat-plus64.exe --cpu-affinity 2 --gpu-devices 1 hashfile wordlist.txt Just trying "oclHashcat-plus64.exe --help" also gives no result, so u suspect the exe file is not starting somehow.,.. RE: -stdout syntax - atom - 04-19-2012 maybe invalid driver, check the homepage to see which one you need to install RE: -stdout syntax - -.-PhanTom-.- - 04-19-2012 Was indeed a driver issue, thanks Running fine now ![]() |