| attacks using hashcat-utils
#1
I have been using hashcat utils(combinator.bin) to combine two dictionaries and piping it into plus to be able to add rules to the combination. This is working fine, however, it would be nice to see a status screen that could be refreshed when it is running so I know how long it is going to take, etc. When I start the attack it just says starting in stdin, it is not until I stop the attack that I am presented with a summary screen. Is the status screen possible today or is that something that maybe can be considered for future releases?

If it needs to be in a future release it would be nice to see hashcat support it natively vs using the pipe. I know I could use combinator and combine two dictionaries to disk, then run it to plus with rules, but it takes a ton of diskspace.


Messages In This Thread
| attacks using hashcat-utils - by powderspecial600 - 12-04-2013, 11:43 PM
RE: | attacks using hashcat-utils - by philsmd - 12-05-2013, 03:49 PM
RE: | attacks using hashcat-utils - by philsmd - 12-05-2013, 04:31 PM
RE: | attacks using hashcat-utils - by philsmd - 12-05-2013, 04:56 PM