Watchdog temperature abort trigger disabled
#3
(04-06-2014, 10:05 PM)coolbry95 Wrote: That version of hashcat does not support it yet. The beta version is the only one that does as of right now. When the 1.20 version is released it will be supported. Also you will want to use od6config if your not already.

Ohh in that case I will need to wait for 1.20 then.

By the way I've installed od6config but it says my card is not supported or something to that effect when I run "od6config --list" or any other command. Will need to check back the exact error message. Can you confirm that od6config can work on R9 280X cards?

Edit
The message that I'm getting whenever I run the od6config command is "No Overdrive6 devices found!". Im guessing that my card is not supported.

Thanks.

Best regards,
Azren


Messages In This Thread
RE: Watchdog temperature abort trigger disabled - by azren - 04-07-2014, 03:34 AM