+- hashcat Forum (https://hashcat.net/forum)
+-- Forum: Support (https://hashcat.net/forum/forum-3.html)
+--- Forum: hashcat (https://hashcat.net/forum/forum-45.html)
+--- Thread: resume hashcat from known progress (/thread-9084.html)
resume hashcat from known progress - amdeusace - 03-29-2020
Hello,
is there any possibility to resume hashcat by known progress?
Progress.........: 4522835968/356085800000
can i start from 4522835968
thank you in advance.
RE: resume hashcat from known progress - philsmd - 03-29-2020
It's not safe in general to restore from some arbitrary progress value.
If you know the restore file that would be much safer:
Code:
Restore.Point....: x/yYou can use the x value with --skip
Of course, the preferred way to doing this would be to use the --restore file
RE: resume hashcat from known progress - juiweasley - 07-12-2023
(03-29-2020, 08:55 PM)amdeusace Wrote: Hello,
is there any possibility to resume hashcat by known progress?
Progress.........: 4522835968/356085800000
can i start from 4522835968
thank you in advance.
Yes, it is possible to resume hashcat from a known progress point. Hashcat supports checkpointing, which allows you to save the current state of the cracking process and resume it later.
To resume hashcat from a specific progress point, you need to follow these steps:
1. Ensure that you have the checkpoint file generated from the previous run. The checkpoint file usually has the extension .restore.
2. Open a terminal or command prompt and navigate to the directory where hashcat is installed or located.
3. Execute the hashcat command with the appropriate options and specify the checkpoint file using the --restore flag.
The command would look something like this:
hashcat [hashfile] [attack_mode] [attack_options] --restore
Replace [hashfile] with the path to the file containing the hashes you are trying to crack. [attack_mode] and [attack_options] should be replaced with the specific attack mode and options you are using. mapquest driving directions
By using the --restore flag, hashcat will load the checkpoint file and continue from the saved progress point. You don't need to specify the progress value manually; hashcat will pick up where it left off based on the information stored in the checkpoint file.
Make sure to replace the example command arguments with the actual values and options you are using for your specific scenario.
RE: resume hashcat from known progress - Snoopy - 07-12-2023
@juiweasley: your cli is wrong, it is simpler than that, see my cli
depends, did you named your session and if not, did you startet by now another cracking task with hashcat?
problem, hashcat names the sesssion per default to hashcat and stores a file called hashcat.restore, without naming your session, these restore file is overwritten any time you start a new cracking task
you could restore any session by simple running
Code:
hashcat --session=hashcat --restoreyou can replace hashcat by any sessionname where a [sessionname].restore file exists