|
No GPU utilization
|
12-04-2012, 01:16 PM
(12-03-2012, 01:56 AM)tinman Wrote: On my use of the rule d3ad0ne the hardware 1 still shows 0%. It seems to only report and use one of my two graphics cards. They are both 5770's and have crossfire. I notice on the AMD control center that card 1 is at 0% and card 2 is at ~95% at 72C.On your command line, you specify -d 2 which means use only GPU2. You have to specify -d 1,2 to get both working. You still need rules to keep them both busy... |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
No GPU utilization - by tinman - 12-02-2012, 04:30 AM
RE: No GPU utilization - by radix - 12-02-2012, 04:34 AM
RE: No GPU utilization - by tinman - 12-02-2012, 04:57 AM
RE: No GPU utilization - by radix - 12-02-2012, 06:01 AM
RE: No GPU utilization - by epixoip - 12-02-2012, 03:30 PM
RE: No GPU utilization - by tinman - 12-03-2012, 01:56 AM
RE: No GPU utilization - by epixoip - 12-03-2012, 09:27 AM
RE: No GPU utilization - by mastercracker - 12-04-2012, 01:16 PM
RE: No GPU utilization - by radix - 12-03-2012, 06:43 AM
|
