(02-19-2014, 04:57 PM)magnum Wrote: Try my fork at https://github.com/magnumripper/od6config - NOTE I could actually not test it from where I sit right now but it just might work...
If/when we get past any teething problems I'll make a pull request to epixoip.
Thanks for that. Just installed your branch and get the following when I run the get voltage command
Code:
allmines@server:~/od6config-master$ od6config --get voltage
Adapter 0: AMD Radeon R9 290 Series
Core voltage : 0 mV (default)
Adapter 1: AMD Radeon R9 290 Series
Core voltage : 0 mV (default)
Is it normal for it to show 0 mV as the default value?