12-02-2011, 12:54 AM
Thanks for the speedy reply. I'm running Windows 7...last I tried, it was a real pain to get Linux running in a triple monitor setup.
I did try maxing out the manual fan speeds last night using the Control Center, but it didn't affect my over heating problem...but I may be having the problem that the fans are actually maxing out at 33%. As far as I can see, there is only one fan...and the rest looks like a heat sink.
How do I change the display/sensor ID? And what exactly does that do? Thanks.
I did try maxing out the manual fan speeds last night using the Control Center, but it didn't affect my over heating problem...but I may be having the problem that the fans are actually maxing out at 33%. As far as I can see, there is only one fan...and the rest looks like a heat sink.
How do I change the display/sensor ID? And what exactly does that do? Thanks.
(12-02-2011, 12:31 AM)chort Wrote: Check out http://hashcat.net/forum/thread-692.html
I need to put that on the wiki today.
PS does it have two fans on the card? You might need to set them independently by either incrementing the display ID or possibly the sensor ID.