Crack WPA2 (.hc22000 file) with list not completing

[v71221]

@ZerBea
Thank you for your prompt reply. Yes, I am a newcomer, diligently studying hcxdumptool/hcxtools and using a test environment. Three notebooks with wifi-adapters, 1st with Linux and hcxdumptool/hcxtools, 2nd with Windows as wifi access point, and 3rd with Windows as client. For clarity and readability I changed MACs on AP and CLIENT.

AP is created by these commands on Windows 7

Code:

netsh wlan set hostednetwork mode=allow ssid=ap01 key=12345678 keyUsage=temporary
netsh wlan start hostednetwork

I ran this command to capture AP-CLIENT session.

Code:

$ sudo hcxdumptool  -i wlan0  -o dump.pcapng  --silent  --enable_status=127  -c 1

I used silent "passive" mode because client hung if I ran hcxdumptool in "active" mode.
Could you kindly provide me with "proper" syntax of hcxdumptool options if I'm targeting PMKID only.

By the way, I noticed that
hcxhash2cap with option "--pmkid=" gives an error "reading hash line 1 failed".
hcxhash2cap with option "--pmkid-eapol=" works fine.
Input file in both cases is the same one-line-file pmkid.22000

Code:

$ hcxhash2cap --pmkid=pmkid.22000 -c test.cap
reading hash line 1 failed: WPA*01*f8dc238fb156874627b5ff251b8ab53c*020000000001*020000000020*61703031***

$ hcxhash2cap --pmkid-eapol=pmkid.22000 -c test2.cap
PMKIDs/EAPOL messages written to capfile(s): 1 (0 skipped)