09-22-2012, 12:19 PM
Hi atom!
Thanks for the kind reply.
Interestingly, John the Ripper (compiled for CUDA-X86-64) works fine, but at a slow 4900 c/s. It does not crash, but the speed is bad.
Not sure if this helps, but if you want, I can give you remote shell to one of my computers with a 690, running Linux.
Let me know.
Thanks,
P
Thanks for the kind reply.
Interestingly, John the Ripper (compiled for CUDA-X86-64) works fine, but at a slow 4900 c/s. It does not crash, but the speed is bad.
Not sure if this helps, but if you want, I can give you remote shell to one of my computers with a 690, running Linux.
Let me know.
Thanks,
P
(09-22-2012, 11:28 AM)atom Wrote: This cuStreamSynchronize() 700 / 999 error is a nightmare. I got several reports for this, all on 6xx cards. Maybe there is a problem with the drivers? I cant reproduce this on mx 560Ti so I cant help on this.