ocl-hashcat-plus v0.08 Freezing.

[Hash-IT]

This is not related to my ocl-hashcat-plus v0.09 beta report. This is for ocl-hashcat-plus v0.08 stable.

I was running through my usual lists and rules files on a .hccap file that works fine with ocl-hashcat-plus v0.07 with ocl-hashcat-plus v0.08 when I noticed that ocl-hashcat-plus v0.08 froze on me.

Using Win7 Ultimate 32bit ATI HD5870 Card Driver Package Version 8.961 OpenGL Version 6.14 against .hccap

My first rule list ...

Code:

l
u
c
r
d
E

My second rule list was suffixing 0-100. (To much to paste.)

After about 180 minutes I noticed that my fan speed had reduced to tick over so I turned the monitor on expecting to see the cracked notification as the time estimate was over 16 hours when I started and as I said this was just about an hour and a half in.

However I am unsure what was happening as I noticed that the WPA had not been cracked but ocl-hashcat-plus had stopped cracking. Well I say "had stopped" I could press "s" and get a status report as if it was still working. The c/s figures were still showing what I would expect to see if it was working full tilt.

I did notice that the Progress and Rejected figures were not changing every time I pressed "s". If ocl-hashcat-plus was rejecting many thousands of passwords due to line length etc, then I would expect to see the Rejected figure to change, but it wasn't doing.

I left it like this for 15 minutes half expecting it to pick up again but it didn't. I continued to press "s" and got the same reply.

I finally stopped ocl-hashcat-plus but I wonder what is wrong ?

Just thought I should mention my temperature was fine, I don't overclock and it usually runs at about 70c - 72c.

Thanks