wrong temperature assignment
#3
Either i misunderstood you or you misunderstood me.
I wanted to say that hashcat does not read correct temperature and fan sensor- look at hashcat output:
From speed it is visible that card is under load, but it says util 0% and temperature is what is normal for idle.
On right (temp/fan output) i wanted to show that card is really under load- higher temperature than other 3 cards on idle and RPM.
I wanted to say that hashcat was not reporting temperature for correct card. When temp was near 80, hashcat still showed 42 and 45°c.

Thank you for reply!


Messages In This Thread
wrong temperature assignment - by martin.po21 - 07-26-2015, 09:26 PM
RE: wrong temperature assignment - by epixoip - 07-27-2015, 12:25 AM
RE: wrong temperature assignment - by martin.po21 - 07-27-2015, 06:48 AM
RE: wrong temperature assignment - by epixoip - 07-27-2015, 10:42 AM
RE: wrong temperature assignment - by martin.po21 - 07-27-2015, 10:48 AM