need batch stop after pass found hccapx
#3
It'll keep looking if you have more than one digest. Remove the other digest and you'll have no more issues. 

Example of a multicap file with 6 hashes: 

Session..........: hashcat
Status...........: Running
Hash.Type........: WPA-EAPOL-PBKDF2
Hash.Target......: capture.hccapx
Time.Started.....: Fri Jan 24 16:59:58 2020 (2 secs)
Time.Estimated...: Fri Jan 24 17:01:43 2020 (1 min, 43 secs)
Guess.Mask.......: 306?d?d?d?d?d?d?d [10]
Guess.Queue......: 1/1 (100.00%)
Speed.#1.........:  289.1 kH/s (415.00ms) @ Accel:512 Loops:256 Thr:256 Vec:1
Recovered........: 3/6 (50.00%) Digests, 3/6 (50.00%) Salts
Progress.........: 0/60000000 (0.00%)
Rejected.........: 0/0 (0.00%)
Restore.Point....: 0/10000000 (0.00%)
Restore.Sub.#1...: Salt:0 Amplifier:0-1 Iteration:768-1024
Candidates.#1....: 3066199999 -> 3064305378
Hardware.Mon.#1..: Temp: 40c Fan: 25% Util:100% Core:2062MHz Mem:4104MHz Bus:16

[s]tatus [p]ause [b ]ypass [c]heckpoint [q]uit =>

For my example when I start this attack it states: 

INFO: Removed 3 hashes found in potfile.

If it had found all 6 hashes in the first attack it will not continue with the following attacks and halt.
Reply


Messages In This Thread
RE: need batch stop after pass found hccapx - by slyexe - 01-25-2020, 01:15 AM