OK, I took out the --remove switch and tried to run it again. Now it just hangs up in the cmd window with a blinking cursor. Let it run for almost 40 minutes and nothing outputted. No error message, no nothing...
Here is a pic I took... not sure if it has any relevance though lol....
![[Image: y3JRnYA.jpg]](http://i.imgur.com/y3JRnYA.jpg)
Edit: Now I notice this at the end of the output file. Am I doing something fundamentally wrong with this??
Hashes: 442180 total, 442090 unique salts, 442117 unique digests
Bitmaps: 21 bits, 1048576 entries, 0x000fffff mask, 4194304 bytes
Rules: 1
Workload: 256 loops, 80 accel
Watchdog: Temperature abort trigger set to 90c
Watchdog: Temperature retain trigger set to 80c
Device #1: GeForce GTX 560, 1024MB, 1701Mhz, 7MCU
Device #1: Kernel ./kernels/4318/m0010_a0.sm_21.64.ptx
Device #1: Kernel ./kernels/4318/bzero.64.ptx
Starting attack in stdin mode...
Here is a pic I took... not sure if it has any relevance though lol....
Edit: Now I notice this at the end of the output file. Am I doing something fundamentally wrong with this??
Hashes: 442180 total, 442090 unique salts, 442117 unique digests
Bitmaps: 21 bits, 1048576 entries, 0x000fffff mask, 4194304 bytes
Rules: 1
Workload: 256 loops, 80 accel
Watchdog: Temperature abort trigger set to 90c
Watchdog: Temperature retain trigger set to 80c
Device #1: GeForce GTX 560, 1024MB, 1701Mhz, 7MCU
Device #1: Kernel ./kernels/4318/m0010_a0.sm_21.64.ptx
Device #1: Kernel ./kernels/4318/bzero.64.ptx
Starting attack in stdin mode...