After update to v1.36, I can't run cudaHashcat64 with following command:
cudaHashcat64.exe -m 2500 PhuLam\RUBY.hccap Dict\090.txt
It always give me following result (picture)
![[Image: image.png]](http://s2.postimg.org/5zuzx3rnt/image.png)
It showed Status of Cracked but there was nothing (even with wrong Dictionary). I'm using Forceware v353.
I still can use that command on v1.20 but because it is outdated so I had to change system clock to be cable to use it.
Pls help me to adjust the command of new 1.36.
cudaHashcat64.exe -m 2500 PhuLam\RUBY.hccap Dict\090.txt
It always give me following result (picture)
It showed Status of Cracked but there was nothing (even with wrong Dictionary). I'm using Forceware v353.
I still can use that command on v1.20 but because it is outdated so I had to change system clock to be cable to use it.
Pls help me to adjust the command of new 1.36.