Using hashcat with maskprocessor - here: veracrypt

[Snoop]

I don't think the mask 'part_I_remember?d?s' does what you want. It tries candidates that start with "part_I_remember" followed by exactly one digit followed by exactly one special character.

I guess it should be something like
-1 ?d?s part_I_remember?1?1?1?1?1?1

your increment-min/max values are calculated for the whole mask, including your prefix.

You may achieve better speed for your specific attack by using -S

Good evening undeath ,
thank you for the hint. You're completely right I think. The error messages seems it.
Now my code is

Code:

hashcat -a 3 -m 13711 -1 ?a?s part_I_remember?!?1?1?1?1?1

and I'll get the hint that I have to specify a mask, when I specify a custom charset.
So I'm looking for how to specify a mask now .
...hmmm immediately I read about it and I'm of the opinion, that ai just have created a mask with my command...

I've found another mistake:

Code:

Hash 'part_I_remember?a?s': Hash-file exception
No hashes loaded.

Is that the part royce told me to do? To extract a hash from my veracrypt volume? How can I do this?

A few posts ago you asked me, why I wrote

Code:

--increment 4:6 (17:19)

Now I've found this syntax again

Code:

Increment:

  -i,  --increment=NUM:NUM  Enable increment mode. 1st NUM=start, 2nd NUM=stop
                            Example: -i 4:8 searches lengths 4-8 (inclusive)

it's part of the hashcat-wiki https://hashcat.net/wiki/doku.php?id=maskprocessor under the point options.