|
Stuck in "hashcat (v3.10-729-gb670e57) starting..."
|
11-17-2016, 05:57 AM
Ok, I think that's the problem then. Last I knew, X had to actually be up on the display to run OpenCL applications,. If you start X then switch to a tty and run an OpenCL application, the OpenCL application will block until X is attached to the display again. I would recommend testing over ssh.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Stuck in "hashcat (v3.10-729-gb670e57) starting..." - by wiredtiger - 11-16-2016, 12:55 PM
RE: Stuck in "hashcat (v3.10-729-gb670e57) starting..." - by epixoip - 11-17-2016, 12:54 AM
RE: Stuck in "hashcat (v3.10-729-gb670e57) starting..." - by wiredtiger - 11-17-2016, 01:02 AM
RE: Stuck in "hashcat (v3.10-729-gb670e57) starting..." - by epixoip - 11-17-2016, 05:57 AM
|
