No Error Msg: Does Nothing

[pinkfloydeffect]

I'm using hashcat-gui and I ran into a problem, when I go to start it I don't get an error telling me to update the oclHashcat-plus folder or anything but the CMD has one line that says "C:\Users\Nate\Desktop\hashcat-gui-0.5.0\hashcat-gui-0.5.0\oclHashcat-plus>" and that is it, does not do anything. Any idea what could be wrong? I'm using the x64 version with an ATI Radeon HD 2600 XT.

[atom]

ATI Radeon HD 2600 XT is not supported

[pinkfloydeffect]

ATI Radeon HD 2600 XT is not supported

Awww, that sucks. Thanks

[pinkfloydeffect]

Tried hashcat in CPU mode but the drop down box for the hash type does not list WPA/WPA2, can anyone tell me if hashcat in CPU mode would be faster at scanning words than aircrack-ng??

[atom]

hashcat CPU does not support WPA

[pinkfloydeffect]

hashcat CPU does not support WPA

Ahhhhh! Ah Ah AHHHHH

[pinkfloydeffect]

Let me just get this straight, the only GPUs supported are high end $300+ cards?? Says CUDA & Stream enabled cards but has no model list, CUDA & Stream must be high end?

[radix]

Let me just get this straight, the only GPUs supported are high end $300+ cards?? Says CUDA & Stream enabled cards but has no model list, CUDA & Stream must be high end?

If you consider a 40-50 dollar card high end, then yes.... you need high end cards.

[pinkfloydeffect]

Let me just get this straight, the only GPUs supported are high end $300+ cards?? Says CUDA & Stream enabled cards but has no model list, CUDA & Stream must be high end?

If you consider a 40-50 dollar card high end, then yes.... you need high end cards.

I was basing this off the ATI hd5970, NVidia gtx570, ATI hd6990 & NVidia gtx580 listed on the Hashcat-plus page. I have tried 4 computers with 128-512mb ram graphic cards with no luck so I figured CUDA & Stream were something new excuse my lack of knowledge here.

[atom]

http://hashcat.net/forum/thread-919.html