hashcat Forum › Support › hashcat v
Maskprocessor Help Windows 10

Threaded Mode
Maskprocessor Help Windows 10
hashnewb Offline
Junior Member
**
Posts: 11
Threads: 2
Joined: May 2020
#11
05-12-2020, 12:57 PM
(05-12-2020, 12:42 PM)philsmd Wrote: Where do you see these percentages ?

Are you talking about the "Util" value in the status prompt of hashcat ?

It's showing 100% Util in hashcat, I was looking at the GPU Utilization in the performance tab in Windows
Find
Reply
philsmd Offline
I'm phil
******
Posts: 2,267
Threads: 16
Joined: Feb 2013
#12
05-12-2020, 01:04 PM (This post was last modified: 05-12-2020, 01:05 PM by philsmd.)
I don't think the task manager will even recognize common OpenCL tools/software. It will just consider a few other/built-in or video editing/media player software etc.

It would probably make more sense to test with some tuning tools like afterburner/GPU-Z etc
Find
Reply
hashnewb Offline
Junior Member
**
Posts: 11
Threads: 2
Joined: May 2020
#13
05-12-2020, 01:41 PM
(05-12-2020, 01:04 PM)philsmd Wrote: I don't think the task manager will even recognize common OpenCL tools/software. It will just consider a few other/built-in or video editing/media player software etc.

It would probably make more sense to test with some tuning tools like afterburner/GPU-Z etc

Good idea, I tested with GPU-Z and it does show its maxing the GPU out. Panic over haha

Do you think 115,000 H/s sounds about right for a NVIDIA GTX 1050 Ti working on WEP2 hashes?

If so I might look at making a rig with 8 graphics cards.
Find
Reply