Control Fan Speed in oclhashcat-plus
#1
I did not see an option present to control the fan speed.

The latest version of Oclhashcat-plus with the mode 150 (special version), makes the fan run at a really high RPM.

How do I control that? This was not happening in the previous versions of oclhashcat-plus.

This makes the fan run at 100% if the GPU loads goes beyond, 95% or so.
#2
you can set --gpu-temp-retain 0
#3
(06-09-2012, 05:24 AM)NeonFlash Wrote: I did not see an option present to control the fan speed.

The latest version of Oclhashcat-plus with the mode 150 (special version), makes the fan run at a really high RPM.

How do I control that? This was not happening in the previous versions of oclhashcat-plus.

This makes the fan run at 100% if the GPU loads goes beyond, 95% or so.

There is an accepted feature request here to set default to 80c.
#4
its already done in this version. maybe his card is above?
#5
Ahh I hadn't thought of that, good thinking.

Shall I change from accepted to implemented on the wiki or do I wait until it is in the standard plus version ? (not this special one).
#6
You can mark it as finished Smile
#7
@atom: Thank you.