New attack on WPA/WPA2 using PMKID

[slyexe]

Am I doing this right?

Step 0: Device is in monitor mode:

Code:

$ iw dev     phy#0         Interface mon0             ifindex 9             wdev 0x3             addr my:v6:ip:addr             type monitor             txpower 0.00 dBm     Interface wlp9s0         ifindex 3         wdev 0x1         addr my:v6:ip:addr         ssid MyWifiStation         type managed         channel 1 (2412 MHz), width: 20 MHz, center1: 2412 MHz         txpower 22.00 dBm

You do not want a virtual interface (mon0). You are not doing it right. Setup your wireless interface into monitor mode: 

Code:

ifconfig wlp9s0 down iwconfig wlp9s0 mode monitor ifconfig wlp9s0 up

Then check that its in monitor and not managed with iwconfig wlp9s0. Once the wireless interface is in monitor mode AND SUPPORTS IT, then you can use:

Code:

hcxdumptool -i wlp9s0 -o test.pcapng --enable_status 1

Should solve your issue.